Corn Grain Harvester Maintenance Guide
corn grain harvesterMaintenance Guide
Maintenance before (I) operation
Clean the air filter air duct, clean the oil filter element and diesel filter element and replace the hydraulic oil, hydraulic oil, and brake fluid; fill the fuel tank with qualified diesel; clean the cooling water and add coolant; check the battery power and charge; test run: Start the idling engine for 5 - 10 minutes, and then disconnect the battery for 5 - 10 minutes to observe whether there is any abnormality.
Check the cutter. Check whether the blade is intact and firm, whether the cutter gap and the tightness of the knife press are reasonable, whether the center line of the movable blade and the blade guard coincides, whether the gap of the knife press is appropriate, and whether the knife cleaner blade is installed smoothly and tightly.
Inspect the harvesting, conveying, threshing and cleaning devices in sequence. The threshing part shall check the nip roller gap, threshing gap and feed chain gap and adjust them.
check the rotating parts. Check the dynamic balance weight; check the tightness of the chain and the adhesive tape, and check whether the transmission adhesive tape is too long or has other abnormalities, and replace them all. In the radial clearance ≤ 0.2mm, the matching radial clearance ≤ 0.3mm, and the axial matching radial clearance ≤ 0.2mm.
check the bolt fastening of high speed, large vibration and heavy load parts and high speed sprocket, composite rubber belt wheel and bearing.
Check whether the roller, fan, header clutch, safety clutch and brake device are reliable and flexible and adjust as required.
check the hydraulic system. Check the hydraulic oil pump, control valve and pipeline, and replace those with serious internal leakage. Damaged should be removed or replaced in a timely manner; dirty hydraulic oil and impurities should be replaced.
check tightness. Check the tightness of the seal matching between the feeding chain at the cutter and the sliding plate at the header side, the double-disconnector cover and the flat tire table, and the joint between the concave plate and the flat tire.
(II) operation
Clean up the debris around the hydraulic pipeline and engine exhaust pipe in time to eliminate fire hazards.
, attention should be paid to the inspection and adjustment of the picking device according to the number of grains on the field and the ground and the breakage of stems.
After each shift is completed, it is necessary to thoroughly clean the instructions for shift maintenance, clean the filter element and transmission tension of the machine, lubricate all parts according to the instructions, and add lubricating oil to all parts.
Prepare harvester accessories and wearing parts. According to the model, characteristics and usage of the machine, prepare the corresponding accessories and wearing parts, and get in touch with the enterprise after-sales service in time, and write down the contact address, telephone number and contact person.
(III) safety operation tips
, the overhaul, maintenance and use of the harvester should be done under the premise of ensuring safety.
When cleaning, cleaning, inspecting and maintaining the harvester, the engine must be turned off.
operator leaves the cab, the engine must also be shut down and the start key must be removed.
When starting the engine, you must honk the horn first to make sure that everyone else is away from the harvester before turning it on.
When two people repair and maintain the harvester together, it is strictly forbidden for another person to rotate the rotating parts without permission.
It is strictly forbidden to smoke in the field, and to prevent fire accidents caused by poor contact of electrical circuits, short circuit, and accumulation of grass debris around the engine exhaust pipe.
